CTP-Xmax

• Gentle development without attacking the aluminium base layer
• Sharp-edged, uniform development – even with fine screens and gradients
• Long bath life and stable development performance thanks to an effective buffering and chelating-agent system
• Low sludge and deposit formation – reduced cleaning and maintenance
• Constant conductivity as a reliable control parameter for replenishment
• User-friendly handling and good environmental compatibility
• Effective protection of the plate coating – increases print-run stability
• Replenishment with dedicated replenisher or developer top-up

Test-run plates with default settings of plate processor.

Recommended temperature range 22° C -26° C, start with 23°C. Dip time: 20-30 seconds, start at 25 seconds.

Top-Up replenishment with developer : 100-180 ml/m² (start at 140 ml) + 150 - 180 ml/h standby.

With replenisher: 60 - 80 ml/m² + 40 - 60 ml/h.

IMPORTANT! Observe the plate manufacturer's recommend exposure settings. Deviations can cause sludge formation!